![]() This may be sufficient enough to use for dead areas instead of the range expanders. You could also boost the signal from the routers by getting the High Gain Antennas ( ). You can only get a roaming network by using the same IP range (192.168.1.? for all routers). But this will not be a problem as most of your customers will use the net whilst in their room. ![]() Using this method will help to share the bandwidth on your wireless network between the routers, although you will not get true roming between rooms where the network crosses due to the different IPs. If you increase the APs radio power, the AP could have a longer transmit range than the. For the IPs of the routers, you just need to make sure that they are on the correct Private IP range eg 192.168.?.? with the class c subnet mask as stated by thorsman 255.255.255.0 Optimize the 5 GHz band first, then focus on 2.4 GHz. They must be set to "detect settings automatically" in the TCP/IP properties. You will also have to set up the gateway router to use DHCP, this will save having to configure anyones laptops. I dont know of theses troubles that youve read about, I have them set up in dead areas and it works great. They can also be set to only rebroadcast a selected signal. You will only need the Linksys Wireless-G Range Expanders in this method if you are having trouble in dead areas. The following is the guide to setup them in repeter mode **&p_li=&p_topview=1 These routers can be configured as repeters too (CAT5) Main Wireless Route Router Configured in repeter mode (CAT5) Router configured in repeter mode You can choose to broadcast your SSID or not or keep the netork open its your choice. Rooms 11-19 would be covered by router2 would be SSID "wireless3" for the SSID WEP key same or diff as above. Rooms 10-18 would be covered by router1 would be SSID "wireless2" for the SSID WEP key same or diff as above Say rooms 1-9 covered by the "gateway" would be "wireless1" for the SSID WEP key what ever you want. There are a few things to consider before making the jump. Which Network As you can probably see, switching to 5GHz requires planning. Next if you want to get a little more creative you can setup three different wireless networks or one big one honestly i would setup three for debugging purposes. There are 2.4GHz products using 802.11g that can match or can be faster that 5GHz 802.11a by using paired radios inside access points instead of one which can increase capacity up to 108Mbps. 5 GHz is using a more modern Wi-Fi standard. If you have a dual-band 802.11ac router, it’s running a 5 GHz 802.11ac network and a 2.4 GHz 802.11n network. But 802.11ac (Wi-Fi 5) only supports 5 GHz. Connect the WAN port of the gateway to your cable modem. connect the WAN port of the two "routers" in to the switch part of the "gateway". If so make one a gateway, then make the other two routers. Can you hard wire the three linksys's together?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |